GSP Software Setting: Use “Static Cling” as the material setting for printing. If you have the Gerber enVision 375 Plotter/Cutter, determine the force by performing test cuts.

Or go to plotter settings “F7” and set the Speed to 50, Acceleration to 50, Sharp Corners to 80 or higher, and Force to 50% or more depending on the age of your blade. A 45 or 60 degree blade is recommended for all cutters cutting this material.

With this thick material and laminate or adhesive, it is recommended to make double cuts by “cutting and pasting back” the cut lines in your design program. In the Gerber Plot program, there is a double cut “check box” under “Device Select” in QuicPlot. If you do not have enVision series Gerber cutter, you will have to determine the settings by test cutting the material.